The NZ harrow – Finer tilth at a faster speed

Rune Stark in field with NZ Harrow

Adversity was turned into success with carefully considered development work. By the early 1980s, Väderstad’s drag harrows began to lose ground.  The drag harrows faced tougher competition from wheel harrows.

Three improvements

With this insight we got to work with a clear future vision of what would be required to regain this lost terrain. A new way of building the frame, a bogie and a more efficient tine were required. The heavy, rigid and fully welded frame was initially constructed with 4 shafts with an eventual goal of a 7.5cm tine spacing – an impossible task. Väderstad’s NZA-Harrows nowadays have 5 or 6 shafts. The bogie was a way to provide stability and adherence. We built this ourselves and then equipped the bogie with a tyre from Trelleborg – which had been developed solely for the new harrow.

Valve gave precision

The hydraulics were US-inspired with a master/slave system, but the problem was the precision required to provide a good enough result. The solution was a non-return valve placed in each cylinder to provide millimetre precision. It meant that we could raise and lower the entire harrow in parallel for the perfect working depth. The tine was developed in several forms, with the best version dubbed the Agrilla – hinting at the Latin word argilla which means clay. The harrows were introduced in spring 1982. Väderstad’s harrows then overnight became the only option for forward-looking farmers.

A few years after this introduction, a hydraulic levelling board was added and provided a huge improvement in harrowing. Eventually the classic levelling board was replaced by a flexing CrossBoard. Double levelling boards were also soon introduced.

Faster and better

The development of the new harrows in the 1980s ran parallel to the trend towards larger tractors and a general size rationalisation in Sweden. The effective Väderstad-harrow was well suited to the new rationale. Bogie and a much stronger frame meant that harrowing could be careful and steady at 12-14km/h instead of perhaps around 8km/h. The higher speed also made for a better result with more fine tilth being generated around the vibrating tines. This meant that you often could reduce the number of passes by one, with the same or even better results. That was a big step forward.

NZ Harrow in field

Since its inception in 1982, the NZ-harrow has been continuously improved. Today the 5th generation of the NZ-model is produced and soon it has been supplied in numbers of 30,000 units.

Read more

Learn more

Read more